| |
 |
 |
 |
|
Clear instructions, but missing key lag bolts. |
Monday, December 31, 2018 |
| Reviewer:
EA from Los Angeles, CA United States
|
|
Kit included 5/16" lag bolts when 1/4" were needed on the main plate. M8 washers were used on the M6 bolts attaching the adapter rails to the TV as the M6 washers would fall in between the holes. But, it's still secure.
The bolts mating the arm to the TV plate had resistance turning. There may be some paint or powdercoating on the threads. It still goes in with hand strength, so not too much to worry about.
For my 300mm x 300mm 65" Sony TV mount (still within weight rating), the adapter rails can't center perfectly on the arm (off by an inch or so horizontally). It ended up looking fine on my wall, but may mess with the OCD of some. If you want things perfectly centered, I would recommend you go with the dual-stud version where you have more adjustability.
Rotation is simple and tension is preset from the factory, but tension can be locked or adjusted by turning some bolts as indicated in the instructions.
Was this review helpful to you? 
|
|
 |
|
 |
|
Easy setup 
