ViewSonic CDE8451-TL Display Tilting Wall Mount with 400lb Capacity

Wall Mount Overview

This super heavy duty wall mount bracket fits ViewSonic CDE8451-TL 84" touch screen display and is rated to support up to 400 Lbs., tested at 4X rated weight. Vertical arm brackets attached to the display allow you to choose either a flat (0 deg) or a 5 deg downward tilt. The bracket is slim with a 1.63 inch thin profile from wall.

VESA Ready
Made in the USA.

Safety Checklist:
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the mounting unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and airflow
Always install so that the load is supported by a wood stud.
Do not install on decorative posts or plaster board.

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel display and the wall mount. Always use at least two persons for all installations. Fully tighten all of the mounting screws as specified in the installation instructions.